Files
ExploringUncertainties/Wiring.md
T

84 lines
2.1 KiB
Markdown
Raw Blame History

This file contains ambiguous Unicode characters
This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.
# Wiring LED Strip
* 240 LEDs
* start of every LED strip is at the female connector
* green: data
* red: 5 VCC
* white: GND
* connect green to DATA_PIN 14, which is A0 on the Arduino
## Wiring with External Power Source (highly recommended)
5V PSU USB → Arduino
└── GND pin ─────────────────┐
└── Data pin (A0) ──────┐ │
│ │
5V PSU ──── VCC ──→ LED Strip DAT GND
└─── GND ──→ LED Strip ───────────────┘
# Wiring Guide: 12 Push Buttons + WS2812B LED Strip on Arduino Uno
## Available I/O Pins on Arduino Uno
| Pin Group | Total | Usable | Notes |
|---|---|---|---|
| Digital D0–D13 | 14 | 12 | Avoid D0/D1 — used for Serial TX/RX |
| Analog A0–A5 | 6 | 6 | Can be used as digital I/O |
| **Total usable** | | **18** | |
## Pin Requirements
- 12 push buttons = 12 pins
- WS2812B data line = 1 pin
- **Total: 13 pins** (fits within the Uno's 18 usable pins)
## Suggested Pin Assignment
| Component | Pin |
|---|---|
| Button 1 | D2 |
| Button 2 | D3 |
| Button 3 | D4 |
| Button 4 | D5 |
| Button 5 | D6 |
| Button 6 | D7 |
| Button 7 | D8 |
| Button 8 | D9 |
| Button 9 | D10 |
| Button 10 | D11 |
| Button 11 | D12 |
| Button 12 | D13 |
| WS2812B data | A0 (used as digital out) |
| A1–A5 | free for future use |
## Button Wiring
Use `INPUT_PULLUP` — no external resistors needed.
- Connect each button between its digital pin and **GND**
- Button reads **LOW** when pressed, **HIGH** when released
```cpp
pinMode(buttonPin, INPUT_PULLUP);
```
## WS2812B Wiring
The strip only requires one data pin.
```cpp
#define LED_PIN A0
#define NUM_LEDS 30
CRGB leds[NUM_LEDS];
FastLED.addLeds<WS2812B, LED_PIN, GRB>(leds, NUM_LEDS);
```
### Power Warning
Each WS2812B LED at full white draws ~60mA. If you have more than ~8–10 LEDs:
- Power the strip from an **external 5V supply**, not the Uno's 5V pin
- Share a **common GND** between the external supply, the LED strip, and the Arduino Uno