2.1 KiB
2.1 KiB
Wiring LED Strip
-
240 LEDs
-
start of every LED strip is at the female connector
- green: data
- red: 5 VCC
- white: GND
-
connect green to DATA_PIN 14, which is A0 on the Arduino
Wiring with External Power Source (highly recommended)
5V PSU USB → Arduino └── GND pin ─────────────────┐ └── Data pin (A0) ──────┐ │ │ │ 5V PSU ──── VCC ──→ LED Strip DAT GND └─── GND ──→ LED Strip ───────────────┘
Wiring Guide: 12 Push Buttons + WS2812B LED Strip on Arduino Uno
Available I/O Pins on Arduino Uno
| Pin Group | Total | Usable | Notes |
|---|---|---|---|
| Digital D0–D13 | 14 | 12 | Avoid D0/D1 — used for Serial TX/RX |
| Analog A0–A5 | 6 | 6 | Can be used as digital I/O |
| Total usable | 18 |
Pin Requirements
- 12 push buttons = 12 pins
- WS2812B data line = 1 pin
- Total: 13 pins (fits within the Uno's 18 usable pins)
Suggested Pin Assignment
| Component | Pin |
|---|---|
| Button 1 | D2 |
| Button 2 | D3 |
| Button 3 | D4 |
| Button 4 | D5 |
| Button 5 | D6 |
| Button 6 | D7 |
| Button 7 | D8 |
| Button 8 | D9 |
| Button 9 | D10 |
| Button 10 | D11 |
| Button 11 | D12 |
| Button 12 | D13 |
| WS2812B data | A0 (used as digital out) |
| A1–A5 | free for future use |
Button Wiring
Use INPUT_PULLUP — no external resistors needed.
- Connect each button between its digital pin and GND
- Button reads LOW when pressed, HIGH when released
pinMode(buttonPin, INPUT_PULLUP);
WS2812B Wiring
The strip only requires one data pin.
#define LED_PIN A0
#define NUM_LEDS 30
CRGB leds[NUM_LEDS];
FastLED.addLeds<WS2812B, LED_PIN, GRB>(leds, NUM_LEDS);
Power Warning
Each WS2812B LED at full white draws ~60mA. If you have more than ~8–10 LEDs:
- Power the strip from an external 5V supply, not the Uno's 5V pin
- Share a common GND between the external supply, the LED strip, and the Arduino Uno