Files

2.1 KiB
Raw Permalink Blame History

Wiring LED Strip

  • 240 LEDs

  • start of every LED strip is at the female connector

    • green: data
    • red: 5 VCC
    • white: GND
  • connect green to DATA_PIN 14, which is A0 on the Arduino

5V PSU USB → Arduino └── GND pin ─────────────────┐ └── Data pin (A0) ──────┐ │ │ │ 5V PSU ──── VCC ──→ LED Strip DAT GND └─── GND ──→ LED Strip ───────────────┘

Wiring Guide: 12 Push Buttons + WS2812B LED Strip on Arduino Uno

Available I/O Pins on Arduino Uno

Pin Group Total Usable Notes
Digital D0–D13 14 12 Avoid D0/D1 — used for Serial TX/RX
Analog A0–A5 6 6 Can be used as digital I/O
Total usable 18

Pin Requirements

  • 12 push buttons = 12 pins
  • WS2812B data line = 1 pin
  • Total: 13 pins (fits within the Uno's 18 usable pins)

Suggested Pin Assignment

Component Pin
Button 1 D2
Button 2 D3
Button 3 D4
Button 4 D5
Button 5 D6
Button 6 D7
Button 7 D8
Button 8 D9
Button 9 D10
Button 10 D11
Button 11 D12
Button 12 D13
WS2812B data A0 (used as digital out)
A1–A5 free for future use

Button Wiring

Use INPUT_PULLUP — no external resistors needed.

  • Connect each button between its digital pin and GND
  • Button reads LOW when pressed, HIGH when released
pinMode(buttonPin, INPUT_PULLUP);

WS2812B Wiring

The strip only requires one data pin.

#define LED_PIN A0
#define NUM_LEDS 30
CRGB leds[NUM_LEDS];

FastLED.addLeds<WS2812B, LED_PIN, GRB>(leds, NUM_LEDS);

Power Warning

Each WS2812B LED at full white draws ~60mA. If you have more than ~8–10 LEDs:

  • Power the strip from an external 5V supply, not the Uno's 5V pin
  • Share a common GND between the external supply, the LED strip, and the Arduino Uno