# Wiring LED Strip * 240 LEDs * start of every LED strip is at the female connector * green: data * red: 5 VCC * white: GND * connect green to DATA_PIN 14, which is A0 on the Arduino ## Wiring with External Power Source (highly recommended) 5V PSU USB → Arduino └── GND pin ─────────────────┐ └── Data pin (A0) ──────┐ │ │ │ 5V PSU ──── VCC ──→ LED Strip DAT GND └─── GND ──→ LED Strip ───────────────┘ # Wiring Guide: 12 Push Buttons + WS2812B LED Strip on Arduino Uno ## Available I/O Pins on Arduino Uno | Pin Group | Total | Usable | Notes | |---|---|---|---| | Digital D0–D13 | 14 | 12 | Avoid D0/D1 — used for Serial TX/RX | | Analog A0–A5 | 6 | 6 | Can be used as digital I/O | | **Total usable** | | **18** | | ## Pin Requirements - 12 push buttons = 12 pins - WS2812B data line = 1 pin - **Total: 13 pins** (fits within the Uno's 18 usable pins) ## Suggested Pin Assignment | Component | Pin | |---|---| | Button 1 | D2 | | Button 2 | D3 | | Button 3 | D4 | | Button 4 | D5 | | Button 5 | D6 | | Button 6 | D7 | | Button 7 | D8 | | Button 8 | D9 | | Button 9 | D10 | | Button 10 | D11 | | Button 11 | D12 | | Button 12 | D13 | | WS2812B data | A0 (used as digital out) | | A1–A5 | free for future use | ## Button Wiring Use `INPUT_PULLUP` — no external resistors needed. - Connect each button between its digital pin and **GND** - Button reads **LOW** when pressed, **HIGH** when released ```cpp pinMode(buttonPin, INPUT_PULLUP); ``` ## WS2812B Wiring The strip only requires one data pin. ```cpp #define LED_PIN A0 #define NUM_LEDS 30 CRGB leds[NUM_LEDS]; FastLED.addLeds(leds, NUM_LEDS); ``` ### Power Warning Each WS2812B LED at full white draws ~60mA. If you have more than ~8–10 LEDs: - Power the strip from an **external 5V supply**, not the Uno's 5V pin - Share a **common GND** between the external supply, the LED strip, and the Arduino Uno