/* - Wiring: connect each button between its pin and GND — no resistors needed. - Open the Serial Monitor at 9600 baud in the Arduino IDE to see the output. */ const int NUM_BUTTONS = 12; const int BUTTON_PINS[NUM_BUTTONS] = {2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13}; bool lastState[NUM_BUTTONS]; void setup() { Serial.begin(9600); for (int i = 0; i < NUM_BUTTONS; i++) { pinMode(BUTTON_PINS[i], INPUT_PULLUP); lastState[i] = HIGH; } Serial.println("Button test ready. Press a button!"); } void loop() { for (int i = 0; i < NUM_BUTTONS; i++) { bool currentState = digitalRead(BUTTON_PINS[i]); if (currentState == LOW && lastState[i] == HIGH) { Serial.print("Button "); Serial.print(i + 1); Serial.print(" pressed! (pin D"); Serial.print(BUTTON_PINS[i]); Serial.println(")"); } lastState[i] = currentState; } delay(50); // simple debounce }